Oracle Lighting Fits Jeep Jk/Jl/Jt High Performance 20W Led Fog Lights Mpn:
Description
A complete High-Powered LED Fog Light replacement for the Wrangler JK, Jeep Gladiator, and Wrangler JL Sahara vehicle applications. This direct-fit fog light features plug-and-play wiring for easy installation. These amazing LED units push out approximately 3000 raw lumens which is guaranteed to light up the night on road or off-road! This rugged design can operate in the worst possible conditions. Each light utilizes a rugged Polycarbonate lamp housing to withstand impact and a Solid-State luminaire design for vibration resistance. The epoxy-sealed electronics avoid moisture and corrosion. Perfect for the off-road adventurer who wants to cover new ground on the trail that never ends.
| PART NUMBER | HALO OPTION |
| 5846-504 | No Halo |
| 5846-001 | White |
| 5846-002 | Blue |
| 5846-003 | Red |
| 5846-004 | Green |
| 5846-005 | Amber |
|
|
ColorSHIFT - No Controller |
Wiring Instructions for JEEP JL / Gladiator JT
HALO WIRING:
White or Amber Halo **Additional wire may be needed**
Note: DRL wire cannot be used as a power source - Tapping into Park Lights will give manual control over LED accessory during daytime driving - LED accessory will turn on automatically in night mode when switch is set to AUTO - For full automatic control over the LED accessory use fuse F52 in the engine compartment fuse panel.
HALO WIRING:
Red, Blue, or Green Halo
Extend Red (+) wire to controller, to toggle switch, existing headlight halo
Extend Black (-) wire to common ground
Wiring Instructions for JEEP JK
Wrangler JL / Gladiator JT Install Video:
Wrangler JK Rubicon Install Video:
**Works for JT Sport models with Tow Package**
Features:
• Black Bezel Color
• Optional Premium ORACLE Halo Pre-installed
• Total 1,600 Lumens Light Output
• High Performance Phillips ZES™ 5W LEDs
• Horizontal and Vertical Adjustability
• Advanced Optics Design for Optimal Visibility
• Precision Beam "No Glare” Output
• 2 Year Warranty
Specifications:
• Input Voltage of Light : 9-36V
• Input Voltage of Halo: 12V
• Wattage: 20W
• Raw Lumens: 3,000
• IP Rating: IP67
• Current Draw: 2.0 A @ 12V
• Uses H10/9145/5202 plug
Latest Product Improvement:
• Improvements in brightness and reliability by adding a constant current LED driver to the main circuit board inside of the lamp to control the halos.
• Increased Reliability- By conditioning the power going into the LEDs this prevents degradation which can shorten the overall lifespan of the product.
• Wider Input Voltage Range- The new SMD Halos can operate on a very wide voltage range from 12V-24V so that voltage spike can not damage the LEDs.
• Brighter/ More Even Light- by moving the heat load of the resistors off the PCB we are able to increase the number of LEDs on the circuit board without thermal issues.
• LED chips upgraded from a Cree LED to a Phillips Luxeon ZES chip.They deliver a very high efficacy 130LM/W ratio while having lower thermal output.
(ORACLE Lighting authentication embossed on the inner lamp bezel)